CONFAST - 3/8" X 4" Stainless Steel Flat Sleeve Anchor
These anchors come packaged with 50 pcs per box and are designed for fastening items to concrete.
Bit size 3/8"
Do not use in vibratory loads
3/8" inch diameter x 4" inch long
Spacing must be a minimum of 10 anchor diameters
Free freight on all orders over $25.00
Products specifications
Bit Size
3/8"
Box Qty
50
Diameter
3/8"
Length
4"
Material
Stainless Steel
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Applications The anchor is made from . This anchor is designed for use in
Head Style The anchor is a Flat Head head
Hole Diameter/Bit Diameter The anchor requires a 3/8" hole to be drilled in the base material (). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Diameter of Anchor The diameter of the anchor is 3/8".
Length Anchor The length of the anchor is 4"
Depth of Hole The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.
Application Video a 3/8" X 4" Stainless Steel Flat Sleeve Anchor
Installing a 3/8" X 4" Stainless Steel Flat Sleeve Anchor
Drill a 3/8" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of is met.
Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
Insert the point of the 3/8" X 4" Stainless Steel Flat Sleeve Anchor into the hole. Make sure that the screw being installed will penetrate the base material a minimum of 1" but no deeper than 1-3/4".
Turn the screw clockwise, applying slight pressure until the head of the screw is snug against the material being fastened.
Always use proper personal protective equipment per manufacturer's and OSHA instructions.
