How to Install Double Expansion Anchors

Installation Instructions for the Double Expansion Anchor

Installing double expansion anchors can be completed in four easy steps. These light to heavy duty anchors can be used when working in concrete, brick and block base material, and can even be used in soft masonry and base materials of questionable strength. A machine threaded bolt is used to expand the Double Expansion Anchor and can be removed and replaced without affecting the holding values of the anchor. These anchors are available in 1/4", 5/16", 3/8", 1/2", 5/8" and 3/4" diameters and are made from a highly corrosive zinc-based alloy called Zamac.

Installation Steps:

Drill hole with carbide tipped bit, based on recommended diameter and depth of anchor.

Insert anchor in hole, tap with hammer, if needed.

Place fixture over anchor.Insert machine bolt through fixture into anchor and tighten.

Drill a hole in the base material with a hammer drill and a correctly sized carbide drill bit for the diameter double expansion anchor you are using. See our technical specifications page for the drill bit size required.
Clean out the hole of all debris.
Insert the Double Expansion Anchor into the hole and tap the fastener lightly with a hammer to ensure it is flush with the base material.
Set the fixture over the Double Expansion Anchor and insert the properly sized machine bolt/screw through the fixture and into the anchor.