Sammys® 3/8" Vertical Threaded Rod Anchor for Light gauge steel, 3/8" - 16 Rod Size, 3/8" x 1" Screw Size - XP 35 - 8153922, 25/Box

Sammys® 3/8" Vertical Rod Anchor for Metal Deck, Purlin or Tubular Steel, 3/8" - 16 Rod Size, 3/8" x 1" Screw Size - 8153922 - XP 35

• Two step installation process
• No custom bracket assembly required
• Reduces installation time and cost

• Threaded rod attachment
• Allows specifiers and designers to engineer systems with fewer attachment points
• Holds from 1146-1783 lbs.

• Installs with SAMMY X-PRESS IT installation tool
• Ensures correct installation torque
• Reduces occurrences of fastener failure due to over driving

Installation

1. Insert the bit receiver with 25/64” drill bit into the chuck of a minimum 18-volt battery operated drill and drill the 25/64” hole through the metal deck at the desired location.

2. Slide the sleeve of the A88X-Press It® over the drill bit until it connects to the receiver.

3. With the internally-threaded portion of the anchor (XP 20, XP 35) positioned inside the socket of the installation tool, secure the square base of the Sammy X-Press® within the square recessed guidelines of the installation tool.

4. Insert the Sammy X-Press® anchor through the pre-drilled hole. Install the Sammy X-Press® anchor to release the expandable portion of the anchor and secure the anchor in the metal deck or purlin to allow vertical orientation of threaded rod.

Important Note: Warranty requires the use of the appropriate Sammy X-Press It® Tool for installations.

STRUCTURAL CONCRETE OVER METAL DECK (Follow steps 1-4 before pouring concrete)

NON-STRUCTURAL LIGHTWEIGHT CONCRETE APPLIED OVER METAL DECK NOT FOR USE WITH AIR DRY DENSITY GREATER THAN 35 PCF (Follow steps 1-4 before the LWC has been applied).