Description
- Tested and approved for use in many of Simpson Strong-Tie's best-selling connectors for both interior and most exterior applications
- Ideal for use in connector applications where more control is desired or using a hammer is inconvenient
- 1/4-in. hex head with 0.370-in. diameter integrated washer reduces cam-out and is stamped with the Simpson Strong-Tie "≠" sign and the fastener size for easy identification after installation
- Shank is specifically designed to match the fastener holes in Simpson Strong-Tie connectors
- Optimized heat treating for ductility and strength
- Size: #10 x 1-1/2 in.
- Hex driver included
- Mechanically galvanized, Class 55 coating meets the requirements for use in preservative-treated and fire-retardant-treated wood per the 2012 and 215 IRC
- Quantity: 500
| Box Qty | 500 |
| Diameter | 0.160" |
| Length | 1-1/2" |
| Material | Mechanically Galvanized, Class 55 |
The information on this page is intended for preliminary guidance only. For complete safety and to verify accurate information, please consult the (PDF linked below) to obtain the manufacturer’s values when selecting the anchors for your project.
The Strong-Drive SD Connector screw is specifically designed to replace nails in certain Simpson Strong-Tie connectors and is the only screw approved for that application. The load-rated SD screw has been tested and approved for use in many popular Simpson Strong-Tie products. In certain applications screws are easier and more convenient to install than nails, and the single-fastener load values achieved by the SD screw exceed those of typical 10d common or 16d common nails. In addition, the galvanized coating makes the SD screw ideal for interior and most exterior conditions.
Application List
- Fastening Simpson Strong-Tie Connectors
Product Information (on Simpson Website)
Package information
3.38 in. x 6.13 in. x 3.75 in., 4.2 lbs.
California Prop 65 WARNING! Cancer -www.P65Warnings.ca.gov
Carton Reference 10707392773402
Pallet Reference 50707392773400
